Recent

Author Topic: Sheet?Side ID on RIP  (Read 3648 times)

0 Members and 1 Guest are viewing this topic.

Offline frailer

  • Sydney, OZ.
  • Global Moderator
  • Supreme Ninja
  • *****
  • Posts: 11819
  • Gender: Male
  • Older, and digitally challenged
  • Gender: male
Sheet?Side ID on RIP
« on: June 10, 2008, 12:45:15 AM »
If one person sees this who doesn't already know it, it's worth the trouble.
Have not been able to find the function, like in PREPS, where it automatically prints PDFs by side, and ID's them at the same time. Here it is, as usual "buried" a little...OK, it's me.... :embarrassed:

In the Print Dialogue Master Box...go to Output Device>Output Device Definition. Under parameters>Flat Grouping button. Uncheck all.
Back in main Window, go to Output Name Definition. Make sure you include <Sheetrank> and <Side> in your name, [after the job...careful to abbreviate so you don't go over the limit.].
When your job prints, you should get the PDFs namd and ID'd by sheet and side.    :cheesy:
Forgotten good guys: Dennis Ritchie, Burrell Smith, Bill Atkinson, Richard Stallman
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Now just an honorary member.

Offline frailer

  • Sydney, OZ.
  • Global Moderator
  • Supreme Ninja
  • *****
  • Posts: 11819
  • Gender: Male
  • Older, and digitally challenged
  • Gender: male
Re: Sheet?Side ID on RIP
« Reply #1 on: June 10, 2008, 12:47:09 AM »
...the other 2 screenshots...LOL, there wasn't much chance of anyone posting in between... :naughty:

Forgotten good guys: Dennis Ritchie, Burrell Smith, Bill Atkinson, Richard Stallman
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Now just an honorary member.