Print Page - How do you square a Polar cutter?

Title: How do you square a Polar cutter?
Post by: DigiCorn on April 29, 2014, 11:30:45 AM

Or a service manual, please, if you have one. Model 76 EM.

Title: Re: How do you square a Polar cutter?
Post by: Joe on April 29, 2014, 11:37:30 AM

Didn't Ann send you one?

Title: Re: How do you square a Polar cutter?
Post by: DigiCorn on April 29, 2014, 12:08:39 PM

No. She didn't have a service manual.

Title: Re: How do you square a Polar cutter?
Post by: Chilbear on April 30, 2014, 05:58:48 AM

I have only seen this once - we had a wider verison. They used a carpenter square and squared the blade to the RHS from the OP perspective. There are 4x1 inch bolts under the table and inside the shroud that align the table to the frame. Once through this stage then the back gauge to the side frame after the large bolts are locked back down. Took about a half hour for a service tech.

Title: Re: How do you square a Polar cutter?
Post by: Farabomb on April 30, 2014, 07:59:35 AM

We have had it done on our EMC 155 but it really didn't stick... or the brilliant bindery has smashed the gate one too many time since then.

Square it but don't replace the broken front limit switch. Genius.

B4Print.com

Press & Post Press => Bindery => Topic started by: DigiCorn on April 29, 2014, 11:30:45 AM