In-house dezinger has created a 'box' to give us a die-cut. We only need the curved left hand side. Need to get rid of the top/bottom/right of the 'box'
OK, can Remove Anchor point, but is there a way of 'breaking the Anchor Point joins, top/left + bottom/left? So then I can delete unwanted?
Couldn't you impose the job in XMF and export a PDF?
It should clip to the bleed margin that you set.
Quote from: Diddler on September 26, 2016, 07:32:23 PMCouldn't you impose the job in XMF and export a PDF?
It should clip to the bleed margin that you set.
Yeah, that workaround was considered. Thankfully, there were a number of other problems, so it's fixed upstream now. How it should be, really.
I think maybe it could be done via Ungroup, or Release Compound Path.
Then delete unwanted... then 'Group' the needed stuff. I'll tool sometime for later possible use.
Am about to open the 2nd attempt for the day, which she's just linked. :shoots_self:
Good luck. Sometimes releasing a compound path gives you all sorts of nightmares.
If it's in Illy, I'd use the scissors tool to cut the box at strategic points, then use the arrow tool to select the individual lines and delete them, leaving the curved line that you want.