Just what the title says, No longer need it here, complete with DONGLE.
robrslitho@fuse.net or 513-594-1954
robrslitho@fuse.net or 513-594-1954
- Welcome to B4Print.com.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
RAMpage / Font Sub Using PDF trap engine
February 24, 2010, 02:07:48 PM
Ok here is the deal. Created PDF files out of Indy CS4, all fonts were properly imbedded.
Ripped PDF using the trap engine, every thing was normal no errors. Problem is one font that was used (Omnes-RegularItalic) The first letter was Italic and the rest of the word was regular.
Should have been all Italics.
Ripped PDF again using our normal Rip 2 Disk profile and the font was OK.
Anybody got any ideas??
Ripped PDF using the trap engine, every thing was normal no errors. Problem is one font that was used (Omnes-RegularItalic) The first letter was Italic and the rest of the word was regular.
Should have been all Italics.
Ripped PDF again using our normal Rip 2 Disk profile and the font was OK.
Anybody got any ideas??
#3
CMS - Proofing - Printers / What do you charge for Proofs?
September 12, 2007, 09:31:35 AM
Ok... so the boss ask me "What is everyone charging for Proofs" and I relpy " What kind of proofs are you reffering to?" he replies " LoRes PDF Proofs and Epson Proofs" I then reply
" I don't know, but I'll find out" so I thought I'd try here first and if no luck I'll spend some undercover investigative phone time.
Thanks in advance.
" I don't know, but I'll find out" so I thought I'd try here first and if no luck I'll spend some undercover investigative phone time.
Thanks in advance.
Pages1