B4Print.com

Workflows => Fujifilm XMF => Topic started by: Tracy on September 27, 2018, 09:36:01 AM

Title: XMF waiting for pages
Post by: Tracy on September 27, 2018, 09:36:01 AM
I have a file that everything looks good page prep went good, looks like everything is fine
but it says it's waiting for pages and won't output, I'm just trying to impose a 68 page into a pdf.
I added plates to see if the outputting the pdf was the problem but it's waiting for pages for the plates too.

I think I've seen this before but can't figure out what it is

fyi: I did this same book yesterday at 8.5x11 but today the book is 5.5x8.5 (info not provided yesterday)!!!
I reduced in indy and output a new pdf
Title: Re: XMF waiting for pages
Post by: Tracy on September 27, 2018, 09:53:23 AM
sheesh, I didn't add the blank on 68 in my new indy file
XMF doesn't tell you that, It's always my fault when it doesn't work :laugh:
Title: Re: XMF waiting for pages
Post by: Joe on September 27, 2018, 11:18:11 AM
Glad we could help Tracy! :rotf:
Title: Re: XMF waiting for pages
Post by: Tracy on September 27, 2018, 01:00:01 PM
Your Welcome!
Waiting for pages? Add a Blank dog gone it!!!!
Title: Re: XMF waiting for pages
Post by: Slappy on September 28, 2018, 07:09:08 PM
I've Added a Blank page too, but forgot to "activate" it in the impo and took me quite a while to figure out why the hell it wouldn't process!!!  :banghead:

p.s. It really should auto-activate pages added to the Section, why else would I be adding them??
Title: Re: XMF waiting for pages
Post by: Tracy on October 01, 2018, 09:34:24 AM
I've done it too but forgot :laugh:

It really should tell you: add a blank dummy!