The key to tri tip is carving against the grain, which is a little tricky because it runs 2 different directions!

Weird how Steve Carell built a time machine 11 years ago and traveled here to be Mike Johnson but no one ever talks about it.

What's the worst that could happen?

That sounds like another Acro glitch without FP whereas elements seem to be missing unless you zoom-in one click, then all is well. 

oK, best I got is a little quicker and a lot safer than copy/paste:
for each sheet - right click and "move or copy"
then pick "new book" and save.
repeat.

Also works similarly in G-sheets, fyi

I bet there's a way, I reached out to a power user and asked...
I played around for a minute and did not see an easy way.

That is cool. I remember missing double burns quite a bit in the early days of CTP.

Thank you for your support! 

I hear you, I went right there because it seemed you had already tried the proper things, cheers Tracy.

Quote from: Tracy on February 05, 2025, 02:51:33 PMNot a bad idea maybe I will rasterize the logo see what happens

It seems unorthodox but it works 

If all else fails, rasterize the whole damn thing at 1200 ppi

Ain't no artifacts in pixels (hopefully)

pull it apart and rasterize the shadow?

Try to flatten maybe?

Here's a pic of the smart mark on a press sheet.
You can see it on the plates too, easier than trying to see the slugs at the bottom (processless plates aren't as easy to see things as regular plates)