I rejected a customer file because I thought it was sent in as RGB.
Just started happening.
Any ideas?
Just started happening.
Any ideas?
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuQuote from: david on March 09, 2020, 03:41:19 PM
not anymore, we used to over at Quad.
Doing gray balance?
Quote from: andyfest on July 27, 2019, 08:04:03 AMQuote from: G_Town on July 16, 2019, 02:39:17 PMShouldn't require it for offset sheetfed printing ever. Only really required in flexo where the plates are raised "rubber"-type plates. Then you need a calculated distortion factor to make up for the raised plate face. Your pressman needs to take a pill.
So this comes up about once a year when the pressroom prints long for some reason and they always bring up "why don't we distort our printing plates" to which I reply because that's an asinine idea.
Is anyone doing this on a regular basis?
Quote from: Joe on July 16, 2019, 04:01:16 PM
We do web growth compensation on all of our web press plates if that is what you mean.
Quote from: Possum on June 24, 2019, 12:14:16 PM
No joy on the question, but just had to say Hi Stranger, welcome back.
Quote from: DigiCorn on January 08, 2019, 03:26:21 PMrotation? puff, puff, pass
puff, puff, pass
Quote from: Slappy on January 06, 2019, 02:55:54 PMCritical question: Do they actually WANT to learn, or...
Quote from: DigiCorn on January 04, 2019, 10:06:12 AMnothing for the clueless employee, but here's a site to help YOU out: https://us.glock.com/
Page created in 0.192 seconds with 17 queries.