But the they are great dont buy the washer use an old coventional plate processor it will do the job or you can do it by hand

Maybe the brisque has a bad hard disk that is communication also check that the rip is grounded is the connection scsi or tsp maybe the cable is being stepped on als check that the brisque is not adding some data like registers or crop mark

In mexico Luscher is considered the best machine and there is service personnel there. A swiss guy has the dealership and he works fine I sold two and he services them. If you don't want them sell them to me
The service company is the following and flying to the us is very cheap to promote turism like 350
Hell Gravure México, S.A de C.V.                  
German Centre 4 3 4.  011(5255) 50205040                  
www.gruposad.com.mx                  
E-MAIL: claraterron_hell@yahoo.com.mx                  

I think you cant bake them but they are great and don't need a lot of laser power I changed a couple of months ago and now I recommend it but if you want to go cheap xing graphics is good enough

Check the vacuum system it is in one of hte long sides you need to clean the filters and let all the water come out the mirror works on air bearing

The delta tower probably lost a disk check that it is on and connected

You need to move the software and dongle and some deltas only work on nt depends on the version but is very easy to install it the scsi card need to be installed and the windows has to be the same version 2000 nt whatever

Print console is always with prinergy just when they are together you don't see it. I rather buy a third party rip I can upgrade whenever I want. I recommend you nexus or a Xitron with first proof just you need a license for a third party rip

Very expensive toupgrade buy nexus

I am sorry for your boss because is so expensive Nexus is better and cheaper. You will get charged for every question and if you want to resell it it is worth nothing because kodak won't service and to service it you need a dongle that only service from kodak have. Hope new buyers read this

I think agfa invested on plates more than machines. The agfa elite is very nice but the processless azura is better and you can hand develope. But anyways htere is a chinese plat xing graphics that is about half the price and is better than fuji

Prinergy is crazy expensive and Nexus does a better Job and cheaper and faster. I use to run a trendsetter 16page and the prinergy wouldn't do it my client changd to Nexus and Kodak has the worst service and if you resell they won't service so you buy an expensive rip that if you want to change it is worth shit. It even is bettre to buy xitron with firstproof

Thank god clients pay more

Does anyone wants to sell their ECrm I may use one

Buy the hard disks or take them from the rip 50 or 40 it is one megabyte scsi 1 get it on the internet or if you want buy a cheap harlequin rip