Signa - reorder press sheets

[DCurry]

I think I found a half-solution. It seems that I can move my folding patterns from one sheet to another, but I can't (easily) reorder the sheets. So I could move sig 1 onto form 2. It will work fine, just gets a little confusing out in the press room and bindery as they are used to Form 1 being the first sig. so if I build the template with a work and turn as the first sheet, then the first sheet will always be work and turn even if I choose to put sig 2 or 3 on it. 

I was hoping someone here might have had some in-depth experience with Signa, but I guess I'm the only one using it currently!

[Joe]

I think I found a half-solution. It seems that I can move my folding patterns from one sheet to another, but I can't (easily) reorder the sheets. So I could move sig 1 onto form 2. It will work fine, just gets a little confusing out in the press room and bindery as they are used to Form 1 being the first sig. so if I build the template with a work and turn as the first sheet, then the first sheet will always be work and turn even if I choose to put sig 2 or 3 on it.

I was hoping someone here might have had some in-depth experience with Signa, but I guess I'm the only one using it currently!

Mark Tonk is a Prinect expert and he tried to login here yesterday but must have forgot his password. He tried to reset it but the email was bounced to me because his email address under his account here is no longer valid. You may be able to find him at other sites but I do not have any contact info anymore since his email address in his account here is no longer valid. Have you tried Print Planet?

[DCurry]

Haven't tried over there yet. I always try here first. It's not even that big an issue, just something I was curious about. 

[kennykt]

I will usually reorder the sheets under the Schemes tab, and then use the All Folding Sheets tab, and plug in the number you want the folding sheet to be under No.

[DCurry]

Yes, I figured that part out but I want to be able to change the sheet order. So if the work and turn form is my second sheet, when I move sig 1 to it I now want that to be the first press sheet.