v4.0.2.4

[born2print]

Just upgraded to 4.0.2.4 (via 4.0.2.3c) and it seems very stable / low risk FYI.

[chris_r]

how long did it take to do the upgrade?  i downloaded it, but havent found the time yet.

[born2print]

Are you already on 4.0.2.3c?
I ask because I had to do a double from 4.0.2.2e to 4.0.2.3c to 4.0.2.4 and it took a little over 1.5 hours.
If you're already on 3c it would be quicker than that.

Edit: Times do not include downloading the .ppu files from Kodak, and they are nearly 1GB each.
Time to synchronize each workstation not included either, but that's pretty quick and painless.

[RiotMac]

I installed this update shortly after it was released. I went from 4.0.2.3. It was the quickest Prinergy update I have ever installed. The servers were shorter than usual and the renderstations only took a couple minutes.

Seems like a pretty stable update. I don't think their was much to the .4 update. The main thing was that it fixed the dropping of the renderstations from Administrator after a reboot.