Hi i am using this CtP for exposing waterless plates -Torray/Presstek- for GTO52 DI and want to try conventional plates
-i presume analog plates will not work so thermal CtP plates are needed right?- without tampering with laser power at all.
As far as i know laser power is increased to carve deeper in the silicon surface, unless the speed of drum is reduced.
Exposure time of plate comes to 2-4 mins
Any ideas what will happen?
Will the CtP break/burn -gods no! -?
The plate will be over exposed?
Thank you in advance
-i presume analog plates will not work so thermal CtP plates are needed right?- without tampering with laser power at all.
As far as i know laser power is increased to carve deeper in the silicon surface, unless the speed of drum is reduced.
Exposure time of plate comes to 2-4 mins
Any ideas what will happen?
Will the CtP break/burn -gods no! -?
The plate will be over exposed?
Thank you in advance