Oris RFP questions... April 10, 2017, 07:51:59 PM So since our older large format proofers have died and I have no idea when management plans to replace them, we are stuck with our 9900 for now. Our Fuji tech only setup our 9900 to run with one paper. Oddly it was setup to run on ORIS Pearl paper, even though we've been running Epson Semi Matte 260 GSM paper. So now I'm trying to get a new RFP setup to work on the paper our older proofer plate maker guy keeps ordering... HP Coated 90gsm 24lb paper. It has a kind of matte finish so I dig through the paper selection dropdown. Nothing close so I choose Enhanced Matte, print the correct linearization form and scan away. I'm getting a density of C 0.93, M 0.66, Y 1.08 and K 1.26.The next step in the manual says to reduce my values by 0.15 to 0.20 more than the actual press we are trying to simulate. My pressmen like to run 1.00 for both cyan and magenta, then 0.95 for yellow and 1.15 for black. How in the heck do I "reduce" my yet lower numbers to be more than 1? This manual makes no sense.I tried setting them in manually but get an error that my numbers are higher than measured and will produce strange results. What do I do?